Tennessee awards contract to repair cracking on I-40 Hernando de Soto Bridge

May 18, 2021

Kiewit Infrastructure Group to start work as early as Wednesday this week

The Tennessee Department of Transportation (TDOT) announced yesterday the emergency bridge repair project for the I-40 Hernando de Soto Bridge has been awarded to Kiewit Infrastructure Group.

TDOT says the selection was based on qualifications, experience, and availability of personnel and equipment. The contractor is expected to start work as early as Wednesday this week.

Last week, TDOT and the Arkansas Department of Transportation said a routine bridge inspection uncovered a crack in the bottom side of the bridge truss, which required the shutdown of the bridge for further investigation. The bridge remains closed to all interstate traffic until further notice. TDOT says the fracture, or crack, is in a steel support beam that is critical to the structure of the bridge.

The repair will be performed in two phases. Both phases will need to be completed before traffic can reopen on the bridge. At this point, TDOT says the agency is unable to project a reopening date.

Phase 1 will require the installation of steel plates on each side of the fractured member. This repair will strengthen the damaged steel plates providing stability needed for crews to install equipment for the permanent replacement of the damaged components and continue bridge inspections. The design of the plates has been completed, and plans were provided to Stupp Bridge Company in Bowling Green, Kentucky for fabrication. Fabrication of the roughly 18,000 lb of steel is expected to be complete by Wednesday, May 19. TDOT forces will be picking up the fabricated plates from Stupp Bridge Company and transport them to Memphis, where they will be ready for the contractor.

Phase 2 design is underway and will be finalized with the input of the contractor. This will enable the department to remove and replace the damaged piece and open the bridge to traffic.

TDOT also now has a webpage dedicated to the bridge repair.

-------------

SOURCE: Tennessee DOT

Sponsored Recommendations

The Science Behind Sustainable Concrete Sealing Solutions

Extend the lifespan and durability of any concrete. PoreShield is a USDA BioPreferred product and is approved for residential, commercial, and industrial use. It works great above...

Proven Concrete Protection That’s Safe & Sustainable

Real-life DOT field tests and university researchers have found that PoreShieldTM lasts for 10+ years and extends the life of concrete.

Revolutionizing Concrete Protection - A Sustainable Solution for Lasting Durability

The concrete at the Indiana State Fairgrounds & Event Center is subject to several potential sources of damage including livestock biowaste, food/beverage waste, and freeze/thaw...

The Future of Concrete Preservation

PoreShield is a cost-effective, nontoxic alternative to traditional concrete sealers. It works differently, absorbing deep into the concrete pores to block damage from salt ions...